Chapter 3 Connectors
28
regulations.
CN Label:
BAT1
CN Type:
2-pin wafer, p=1.25 mm
CN Location:
See
Figure 3-4
CN Pinouts:
See
Table 3-5
This is connected to the system battery. The battery provides power to the
system clock to retain the time when power is turned off.
Figure 3-4: Battery Connector Location
Pin
Description
1
VBATT
2
GND
Table 3-5: Battery Connector Pinouts
3.2.4
Chassis Intrusion Connector
CN Label:
CHASSIS1
CN Type:
2-pin header, p=2.54 mm
CN Location:
See
Figure 3-5
CN Pinouts:
See
Table 3-6
The chassis intrusion connector is for a chassis intrusion detection sensor or
switch that detects if a chassis component is removed or replaced.
Figure 3-5: Chassis Intrusion Connector Location
