IDTECK LX007, Руководство пользователя, Страница: 97 / 107

p.89 Cards which were being used are not authenticated after executing batch transmission of
IDs from software to the device.
1.2 Please check if the communication address is good.
Check communication address setting of software and the device.
1. Check if communication ID set in the device is same with communication ID set in a soft
ware.
See [ 12 Setting Changes ] > [ 1 F1 SETUP MENU ] > [ 1.7 Communication Address Setting
] and check a communication address set in the device.
2. When you use several devices together, communication addresses set in the devices sh
ould be different from each other.
3. Check if baud rate is same with baud rate set in a software.
See [ Setting Changes ] > [ F1 SETUP MENU ] > [ 1.8 Baud Rate Setting ] and check baud r
ate set in the device.
* If you initialize the device, baud rate is set to 57,600 bps which is the default.
1.3 Please check if the communication port setting is good.
Check if communication port set in software is same with communication port set in PC.
If the problem persists, please contact service center.
2 Cards which were being used are not authenticated af
ter executing batch transmission of IDs from software
to the device.
2.1 The ID of the card may not be registered to software.
1. Check if the ID is registered to software.
2. If the ID is not registered, register the ID to the software and execute batch transmissio
n of the IDs from software to the device.