ID TECH Kiosk V User Manual
Page | 22
10.
Kiosk V Low-Level Commands
The following are commonly used commands for the Kiosk V. For a full list of available commands,
contact your ID TECH representative for the NEO 2 Interface Developer’s Guide.
10.1.
Activate Transaction Command (02-40)
The
Activate Transaction
command begins a contactless EMV or contactless MagStripe Card
transaction.
Note:
While an
Activate
command is in progress, readers only accepts a
Cancel
or
Stop
command.
Do not send other commands until
Activate Transaction
has completed, because the reader will
interpret these as a
Cancel Transaction
command.
Command Frame
Byte 0-9
Byte 10
Byte 11
Byte 12 Byte 13
Byte 14 …
Byte 14+n-1
Byte 14+n Byte 15+n
Header Tag
& Protocol
Version
Command
Sub-
Command
Data
Length
(MSB)
Data
Length
(LSB)
Data
CRC (LSB)
CRC (MSB)
ViVOtech2\0
02h
40h
See Data
Format below
Activate Transaction Command Frame Data Format
Data Item Length (bytes)
Description
Timeout
1
Time in seconds that the reader waits for a card to be presented
before timing out and returning an Error response. The reader will
continue to poll for this amount of time if no card is found.
Note that if a card is found, the transaction may not complete
within the timeout period.
This field must be present in the
Activate
command.
Format: Binary
TLV Data
varies
See Activate Command TLVs in the
NEO IDG
.
