90
IDS X-Series Training v2.7
Alarm Memory
The alarm memory will hold information from the last time it was armed. When the alarm is armed again
the memory clears and will store information from that alarm system arm period.
The alarm memory holds information on:
2.
Violated zone
a.
Zones that triggered while the system was armed
3.
Bypassed zones
a.
Zones that where bypassed when the system armed, making them ineffective.
4.
Tampered zones
a.
Zones that someone may have opened and messed about with to stop it functioning
correctly.
5.
Event log
a.
This is a history of all system messages, going back a thousand events. Once the system
reaches the thousandth event it will start over writing from the oldest event.
User Codes
1.
128 user codes can be programmed into the system.
2.
The only code pre-programmed into the system is User 1 which is a master code, and it is defaulted
to 1234.
a.
A master code is the administrator of the system, which can do the following.
i.
Add and delete users
ii.
Configure user settings
iii.
Set the time and date
iv.
Teach remote transmitters to a user code
3.
From version 2.7x you can edit user codes by using its slot number without knowing what the user
code is.
Standard Master User Functions
The master menu is for administering the system by adding, deleting users, adding remote transmitters, etc.
To access the master menu press and hold the [*] key until the beep, about 3 seconds, then enter the
master code [1][2][3][4] followed by the [*] key.
Explanation
Key Presses
Press and hold the [0] bypass key until the beep
[0]
The violated zones will be displayed
Press the [2] for bypassed zones or the [3] key for tampered
zones or the [6] key for the event log
Option
Description
1
Violated Zones
2
Bypassed Zones
3
Tampered Zones
6
Event Log
When complete press the [#] key
[#]