MSD-62 Series User’s Guide
81
9.7.4 Automatic detection of video input interruption
Menu Top
→
INPUT SETTING
→
INPUT OFF CHECK
Setting for Each input channel
Setting value ON [Default], OFF
The MSD stops outputting video immediately after input video signal is disconnected even for a moment.
Use this feature to minimize switching artifacts produced by an external device connected to the MSD’s input
connector. The effect of this function is similar to switching the MSD’s input.
9.9.5 Window transaction effect
9.9.6 Window transaction speed
Notes:
・
If you select “ON” and are using a video input (VHS tapes or the like) with a poor quality signal, it’s possible
that the output will flash on and off. This is due to sync signal distortion that can be interpreted as periods of
time without signal presence. In this case, set this menu to “OFF”.
・
Even if you set this feature to “ON”, distorted video cannot be corrected completely when input video signals
are lost. Especially if you set “
9.9.5 Window transaction effect
” to an option other than “CUT”, noises or
black bars may be output at the time of fading out or wiping out.
9.7.5 Selecting signal of DVI input connector
Menu Top
→
INPUT SETTING
→
INPUT AD TYPE
Setting for Each input channel, DVI connector only
Setting value DIGITAL [Default], ANALOG
You can select either digital or analog format.
9.7.6 HDBaseT input long reach mode
Menu Top
→
INPUT SETTING
→
LONG REACH MODE
Setting for HDBaseT input channel
Setting value
・
OFF : Long reach mode disabled. Up to 328 ft. (100 m) [Default]
・
ON : Long reach mode enabled. Up to 492 ft. (150 m)
You can enable / disable long reach mode for HDBaseT input.
With long reach mode, up to 1080p (24 bit)/ dot clock 148 MHz is supported when using with IDK’s HDbaseT
product. Set the MSD’s EDID to 1080p or less or set the connected device’s output to a supported signal
format.
【
See: 9.11 EDID
