MSD-501/502/701/702 User
’s Guide
54
7.8.12 CEC connection
Menu Top
→
OUTPUT SETTING
→
CEC CONNECTION
Setting for Each output (each OUTA / OUTB)
Setting value
・
NOT CONNECTED [Default]
・
SELECTED CHANNEL
・
IN1 to IN3 (MSD-501 / 502)
・
IN1 to IN4 (MSD-701 / 702)
You can set which I/O to be connected when a device supporting CEC is connected.
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.
Notes:
■ Using CEC may cause negative effects. If you do not use CEC, set this menu to “NOT CONNECTED.”
If the status of the sink devices connected to the HDMI output connector changes (such as being turned
OFF
→
ON) or if the CEC connection changes, the EDID may also need to be changed (the MSD changes
it automatically) in order to update the address of the connected device. When the EDID is changed, the
source device stops outputting video temporarily. Note the following points to not make the EDID change
at the time of operation.
■ CEC connection is a one-on-one basis; it cannot connect multiple inputs and outputs. If you set multiple
outputs to connect to the same input, only a smaller output number is connected preferentially and other
outputs are not connected. For example, if you set both OUT1 and OUT2 to IN2, OUT1 is connected to
IN2, while OUT 2 is not connected.
7.8.13 HDCP re-authentication
Menu Top
→
OUTPUT SETTING
→
HDCP AUTHENTICATION
Setting for Each output (each OUTA / OUTB)
If a sink device supporting HDCP is connected, HDCP is authorized automatically. You can re-authorize
HDCP manually using this menu (connection Reset is performed automatically, but it can be performed
manually using this menu). Press the MENU/SET key to perform the re-authentication.
