MSD-501/502/701/702 User
’s Guide
50
7.8 Output settings
7.8.1 Output equalizer
Menu Top
→
OUTPUT SETTING
→
OUTPUT EQUALIZER
Setting for Each output (only OUTA)
Setting value OFF [Default],LOW,MIDDLE,HIGH
HDMI input connector has an equalizer circuit to correct attenuated signal caused when a long cable is
connected. Set the output equalizer according to the cable length.
[Table 7.6] Output equalizer
Cable length
Shorter than10 m/32.8 ft.
10 m/32.8 ft. or longer
Equalizer setting OFF to MIDDLE
LOW to HIGH
(IDK
’s cable, AWG 24, was used.)
7.8.2 Output mode
Menu Top
→
OUTPUT SETTING
→
OUTPUT MODE
Setting for Each output (each OUTA / OUTB)
Setting value
・
HDMI YCbCr4:4:4 MODE [Default]
・
HDMI RGB MODE
・
DVI MODE
・
HDMI YCbCr4:2:2 MODE
You can select an output mode.
Set the mode
to “HDMI YCbCr4:4:4 MODE” to output video with the optimal mode automatically even if a sink
device that does not support HDMI component signal or DVI signal is connected. If you want to output video
with HDMI RGB signal or DVI signal forcibly, set the desired mode.
The MSD checks signal types in order of the table below and output signal with the first matched signal type.
[Table 7.7] Output mode priority
Output mode
Signal supported by sink device
DVI
HDMI
RGB
HDMI
YCbCr4:2:2
HDMI
YCbCr4:4:4
DVI MODE
1st
-
-
-
HDMI RGB MODE
2nd
1st
-
-
HDMI YCbCr4:2:2 MODE
3rd
2nd
1st
-
HDMI YCbCr4:4:4 MODE
4th
3th
2nd
1st
