IDK MSD-402, Справочник по командам

Страница: 64 / 85

MSD-402 Command Guide
64
3.3.10 Communication setting
@GCT / @SCT RS-232C communication
Function Getting Setting
Format @GCT @SCT, port, setting
Return value @GCT, setting @SCT, port, setting
Parameter setting: Communication setting
・
Baud rate (4800, 9600, 19200, 38400 [bps] [Default] 9600)
・
Data length (8, 7 [bit] [Default] 8)
・
Parity check (NONE, EVEN, ODD [Default]: NONE)
・
Stop bit (1, 2 [bit] [Default] 1)
For setting values, see the table below.
port: connector
1 = terminal block
Example @GCT
@GCT,24
Getting communication settings of
RS-232C.
All baud rates = 19200 [bps], data bit
length = 8 [bit], parity check = None, stop
bit = 1 [bit]
@SCT,1,24
@SCT,1,24
Setting RS-232C connector as follows:
baud rate =19200 [bps], data bit length =
8 [bit], parity check = NONE, stop bit = 1
[bit].
Completed normally.
Remarks Once IP address or RS-232C communication setting is changed, the communication
may be disabled. Change the environmental settings of communication based on the
MSD settings.
[Table 3.1] RS-232C communication setting parameter
Value Communication Value Communication Value Communication Value Communication
0 4800 8 NONE 1 12 9600 8 NONE 1 24 19200 8 NONE 1 36 38400 8 NONE 1
1 4800 8 NONE 2 13 9600 8 NONE 2 25 19200 8 NONE 2 37 38400 8 NONE 2
2 4800 8 ODD 1 14 9600 8 ODD 1 26 19200 8 ODD 1 38 38400 8 ODD 1
3 4800 8 ODD 2 15 9600 8 ODD 2 27 19200 8 ODD 2 39 38400 8 ODD 2
4 4800 8 EVEN 1 16 9600 8 EVEN 1 28 19200 8 EVEN 1 40 38400 8 EVEN 1
5 4800 8 EVEN 2 17 9600 8 EVEN 2 29 19200 8 EVEN 2 41 38400 8 EVEN 2
6 4800 7 NONE 1 18 9600 7 NONE 1 30 19200 7 NONE 1 42 38400 7 NONE 1
7 4800 7 NONE 2 19 9600 7 NONE 2 31 19200 7 NONE 2 43 38400 7 NONE 2
8 4800 7 ODD 1 20 9600 7 ODD 1 32 19200 7 ODD 1 44 38400 7 ODD 1
9 4800 7 ODD 2 21 9600 7 ODD 2 33 19200 7 ODD 2 45 38400 7 ODD 2
10 4800 7 EVEN 1 22 9600 7 EVEN 1 34 19200 7 EVEN 1 46 38400 7 EVEN 1
11 4800 7 EVEN 2 23 9600 7 EVEN 2 35 19200 7 EVEN 2 47 38400 7 EVEN 2