FDX-64 User
’s Guide
18
5 Connecting external devices
5.1 Preparation
Prepare necessary cables before connecting external devices such as source and sink devices.
● For digital I/O slot board: DVI cable
● For HDBaseT I/O slot board: HDBaseT cable
● Optical I/O slot board: Optical fiber cable
■ DVI cable
For DVI input and output, please use a single-link cable of DVI-I or DVI-D (male connector). Analog
signals cannot be input or output, and dual link is not supported. If you use a 5 m/16.4 ft. or longer cable
for input or output, please use an IDK
’s cable (AWG24).
[Fig. 5.1] Single sink long cable
For HDMI connectors, please use one of the following conversion cables.
Part number
Length
CBL-DH-015A
1.5 m/4.92 ft.
CBL-DH-03A
3 m/9.84 ft.
CBL-DH-05A
5 m/16.4 ft.
[Fig. 5.2] Conversion cable (HDMI-DVI conversion)
Note:
Since DVI signals are very fast, use a cable meeting the DVI Rev1.0 standard. (IDK
’s cables meet the
standard.)
■ HDBaseT cable
Use a UTP/STP cable meeting Cat5e/Cat6 standard.
■ Optical fiber cable
Use a duplex fiber whose both sides have a LC connector or two simplex fibers. The length of the cable
must meet the standard of the extended distance.
Part number
Length
DVIP/DVIP-S10
10 m/32.8 ft.
DVIP/DVIP-S15
15 m/19.21 ft.
DVIP/DVIP-S20
20 m/65.62 ft.
DVIP/DVIP-S30
30 m/98.43 ft.
DVIP/DVIP-S40
40 m/131.23 ft.
DVIP/DVIP-S50
50 m/164.04 ft.
