FDX-08 User Guide
57
8.5.10 Dissolve effect [OUTPUT FADE OUT-IN]
Menu
OUTPUT TIMING
→ OUTPUT FADE OUT-IN
Setting for
Each output connector (OUT1 to OUT8)
Setting value
ON : Enabled [Default]
OFF : Disabled
Note:
Only channels of scan converter output board can be selected in this menu.
8.5.11 HDCP output [OUTPUT HDCP]
Please set “AUTO” normally. If “AUTO” is set, FDX does not output HDCP until input channel which has
HDCP is selected. Once input channel which has HDCP is selected, FDX outputs HDCP always after the
selection.
If “INPUT ONLY” is selected, FDX outputs HDCP only if input signal has HDCP. However, some sink devices
may fail HDCP authentication sometimes when signal changes from HDCP OFF to ON and not output video
and audio temporary.
If sink devices which do not support HDCP are connected, FDX outputs signal which does not have HDCP
regardless this menu.
Menu
OUTPUT TIMING
→ OUTPUT HDCP
Setting for
Each output connector (OUT1 to OUT8)
Setting value
AUTO
: HDCP is not output until an input channel with HDCP is selected. [Default]
INPUT ONLY : HDCP is encrypted only if input signal is with HDCP.
Note:
Only channels of scan converter output board can be selected in this menu.