DDC-03UHD User
’s Guide
30
8.2 Output equalizer
If video is still interrupted even with the input equalizer enabled, enable the output equalizer.
【
[Table 8.3] Cable equalization
*Default: Disabled
8.3 Audio input Enabled / Disabled
This function controls audio output of source device using the audio information of Built-in EDID.
Only Built-in EDID of GROUP 1
’s No.0 to No.6 and GROUP 2’s No.0 to No.D are supported.
Audio information is registered in the Built-in EDID. If you do not want to output audio from a source device,
set DIP switch5 to
“ON”. When the DIP switch is operated, the source device acquires the Built-in EDID and
outputs audio according to the EDID.
[Table 8.4] Audio setting
Default: Linear PCM
Note:
If an HDCP 2.2-supported source device and monitor are connected and the audio input function of the
DDC-03UHD is disabled, signal that is not in line with the specification may be output and it may cause snowy
video.
Enabled / Disabled
SW4
Disabled*
OFF
Enabled
ON
Audio format
Sampling
frequency (kHz)
Number of
speakers
Speaker
configuration
SW5
Linear PCM*
32 / 44.1 / 48
2
FR / FL
OFF
None
None
None
None
ON