Idis DR-2516P, Руководство по эксплуатации

Страница: 71 / 139

Part 2 - Configuration
71
– Daytime Setup : Specify when daytime starts
and ends. Adjust the time frame in 15-minute
increments. Times outside the specified range will
be assumed as nighttime by the system.
●
Condition : When a specific event occurs, you can set
the condition that determines whether to operate
motion according to the status of other events.
–
Reference Only
: Set the event to be the subject of
a reference.
– Event : Set the reference event.
–
Channel
: Set the reference channel.
●
Actions : Specify which actions to take when Trip Zone
is detected.
– Record : Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
–
Alarm-Out
: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify : Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
– PTZ : Moves the PTZ camera to a specific preset
position when an event occurs.
–
Event Monitoring:
Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
Video-Analytics_Tampering
●
No.
: Select which cameras to apply Tampering to.
●
Sensitivity : Set to between 1 (Low) and 5 (High).
● Activation Time
: Specify how long tampering
detection needs to last in order for it to be considered
an event. Tampering detections that do not last for
the specified duration of time will not be considered
as events.
●
Ignore Condition
– Use Ignoring Time : Select Time Setup to specify
the tampering detection ignore time of camera
channels. Tampering detection will be disabled
during the specified time frame.
●
Actions : Specify which actions to take when
Tampering is detected.
– Record : Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to
Event
or
Time & Event
mode, the selected
cameras will begin linked recording when an event
occurs.
–
Alarm-Out
: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
– PTZ : Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occur.