Part 2 - Configuration
65
Camera System
A list of events that occur in the camera except for video
analysis.
Camera System_Audio Detection
●
No.
: Select which cameras to apply Audio Detection
to.
●
Sensitivity
: Set to between 1 (Low) and 5 (High).
●
Activation Time
: Specify how long audio detection
has to last in order for it to be considered an event.
Audio detection that do not last for the specified
duration of time will not be considered as events.
●
Ignore Condition
–
Ignoring Interval
: The system does not produce
event log entries or remote notifications for audio
detected within a certain period of time after the
audio of the camera channels is detected. Set a
value between 1 sec and 5 secs or choose
Never
.
–
Use Ignoring Time
: Select
Time Setup
to specify
the audio detection ignore time of camera
channels. Audio detection will be disabled during
the specified time frame.
●
Actions
: Specify which actions to take when audio
detection events occur.
–
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
–
Alarm-Out
: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
–
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
–
Event Monitoring:
Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
