Idis DirectIP DC-S Series, Руководство по установке

Страница: 9 / 21

Part 1 – Introduction
9
Overview
Product color and design may vary depending on the
model.
Body
1
4
3
2
5
6
7
8
1
Mount
2
Pendant
3
Body Assembly Standards
4
Lens
5
IR LED
6
Wiper
7
Factory Reset Button
8
SD Memory Card Slot
• Body Assembly Standards
For tightening the body.
•
Lens
AF Zoom Lens is mounted.
• IR LED
A sensor in the middle monitors lighting levels and
activates the IR LED during low-lighting conditions.
• Factory Reset Button
Restores the camera's default factory settings. For
more information, refer to the
Factory Reset .
•
SD Memory Card Slot
Used to insert a microSD memory card into
the camera. (An SLC (Single Level Cell) or MLC
(Multi Level Cell) card by SanDisk or Transcend is
recommended) Make sure that the cover is joined
properly when screwing it; otherwise, the IP66 level
is not guaranteed.
• To remove/insert the SD memory card or
perform the factory reset, make sure that the
cover is joined properly when screwing it.
Otherwise, the IP66 level is not guaranteed. For
more information, contact your product retailer.
• Do not remove the SD memory card while the
system is in operation. Removing the card while
the system is in operation can cause the system
to malfunction and/or corrupt data stored on
the SD memory card.
• An SD memory card is a consumable product
with a finite service life. Prolonged use will
damage the card's memory sectors and result
in data loss or memory card failure. Test the SD
memory card regularly and replace it whenever
necessary.