Part 1 – Introduction
10
Installation
•
Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall or
ceiling is not strong enough to support its weight.
•
Install the camera in a shaded area. If the camera
is installed in direct sunlight, it may be affected
adversely.
Use the provided guide pattern to check the distance
between the screw holes if necessary.
1
Use the screws, anchors provided with the camera to
secure the body on a wall or a ceiling.
2
Connect the network cable like the following
picture.
Closing the Top Cover
1
Attach the top cover to the bottom cover. Turn the
top cover clockwise to fasten it.
If the network cable comes out as shown below, use a
nipper to cut out the cable access hole in the top cover.
2
Adjust the angle. For more information, refer to the
.
