Operator Manual ilex with IPS500A
L280-0688 REV C
Speakers
To use the speakers with an external audio device with Bluetooth® capability,
perform the following steps:
1.
Ensure that the green toggle power switch is on and lit up.
2.
On the cart’s audio control panel, ensure that the “INPUT SELECT” switch is set
to “BT.”
3.
Turn the power on to the Cart’s audio system by turning the rotary Volume Control
knob clockwise so that the red PWR light lights up.
4.
If the system doesn’t automatically sync, press in the white Volume Control knob
button and hold it in for 3 seconds (or until the 'BT' Bluetooth® indicator light
begins to blink. (You may also hear the system prompt say 'Power ON').
5.
Turn on a Smart Device and locate a list all available Bluetooth devices. The
Network Name will appear as 'PYLEUSA' on your Smart Device list. No password
is required to connect, but if you are prompted, enter '0000' (4 zeroes).
6.
As the Smart Device and the cart are synchronizing, the LED indicator light on the
cart will blink progressively quicker and you will hear the system prompt 'Paring.'
7.
When a successful connection is established, the LED indicator light on the cart will
stay lit without blinking and you will hear the system prompt, 'Your device is
connected', indicating that the unit is ready to transmit audio.
(Note: Audio Devices can also be connected to the Cart using cables that have a 3.5mm Aux
Jack or a ¼in. Microphone Jack. Move the “Input Select” switch to the corresponding format
and adjust the volume as desired.)
StableCable
™
cable management system
IDI’s StableCable cable management system keeps external video signal cables firmly locked in
place to prevent their terminations from being pulled out of the panel on the unit. It also tucks
the external cables neatly along the back of the ilex neatly out of the way. The StableCable is
located on the back of the ilex just below the external cable ports. Instructions on how to use the
system is as follows:
Operating Instructions to insert cable:
1.
Press downward on blue cam’s tapered end to allow room to seat cable in groove of grey base.
2.
Lay cable into groove.
3.
Push upward on blue cam’s tapered end gently until teeth of blue cam is pressing against cable.
4.
Grab cable hanging down below StableCable and gently pull down until blue cam is snug against
cable.
