Operator Manual Aspect 100UC Plus
L100-3065 REV C
SETUP
Unpack
No special handling is required for unpacking this equipment at the site. Conventional
shipping materials are used.
To remove the table from the shipping pallet, first remove the shipping brackets that
secure the table to the wooden pallet using a 9/16” wrench. Then roll the table down a
temporary ramp or lift off pallet with a forklift. When using a forklift, pad the forks to
protect the paint. Lift from under the metal base. When rolling the table off the pallet by
hand, use the long metal rails attached to the tabletop to guide the table after releasing
the caster brakes.
Upon receipt of product and before placing table into service, table condition and
functionality should be reviewed by a Biomed or equivalent in-house support/service
resource.
Install
Mobile tables are equipped with four locking caster brakes. Unlock brakes while
positioning.
Hand and foot controls are standard with this table. The operator should become familiar
with the controls before using.
The table operates on 110Vac (or 230Vac) or on internal battery backup. Plug the AC
power cord into a properly grounded hospital grade outlet. The green indicator on the
control box with illuminate, however, the hinged cover will need to be opened to see the
green indicator.
The outlet used should be visible and accessible to the user. The cord should be routed
where it will not be subject to damage or be a hazard. Check that the power cord ground
Recycle or dispose of shipping
material per local regulations.
