Operator Manual
Aspect 100-4T and ISR
L100-2843 Rev. E
22
10.2.
Patient Restraint Straps.
The Patient Restraint Straps can be used in two different ways depending on where the strap is
to be located along the length of the Tabletop. If the strap is to be used on the end of the table
that has the two long accessory rails,
then the whole strap drapes over the
Tabletop, hangs down between the rails
and the tabletop and wrapped over the
outside of the rails to meet over the top
of the table. If the strap is to be used
along the rest of the tabletop, slide the
strap over the end of the table with the
thin part of the strap over the Tabletop
and the thicker part under the tabletop.
The ends of the strap meet over the top
of the table and connect with hook and
loop fasteners.
WARNING!
Strap configuration is recommended; however, patient
restraint is a case-by-case condition. Please refer to
facility’s policy on
restraining a patient.
