Operator Manual
Aspect 100-4T G3 and ISR
G3
L100-2843 28-MAR-2018
16
9.
STANDARD ACCESSORIES
9.1.
Patient Mattress Pad for Tabletop.
The Patient Mattress Pad is held in place by hook and loop fasteners. To remove the pad, simply
pull pad up gently to remove. Replacement pads are supplied with new self-adhesive fasteners
installed and new adhesive backed mating pieces for the tabletop. Peel off old fasteners from
Table Top. Peel off the protective paper and carefully put new pad into position. Apply pressure
to complete installation.
Note: Pad complies with California Technical Bulletin 117.
9.2.
Patient Restraint Straps.
The Patient Restraint Straps can be
used in two different ways depending
on where the strap is to be located
along the length of the Table Top. If
the strap is to be used on the end of the
table that has the two long accessory
rails, then the whole strap drapes over
the Table Top, hangs down between the
rails and the tabletop and wrapped over
the outside of the rails to meet over the
top of the table. If the strap is to be
used along the rest of the tabletop, slide
the strap over the end of the table with
the thin part of the strap over the Table
Top and the thicker part under the
tabletop. The ends of the strap meet
over the top of the table and connect
with hook and loop fasteners.
WARNING!
Strap configuration is recommended; however, patient
restraint is a case-by-case condition. Please refer to
the facility’s policy on restraining a patie
nt.