Operating Instructions
IDEM Safety Switches
NET-BOX-CS
102638 2305 NET-BOX-CS Operating Instructions
6
Setting via DHCP
1.
Apply power to the NET-BOX, after a start-
up period the ‘MS’ LED should be
flashing green.
2.
Using a PC station that is configured on the same network as the NET-BOX, run the BOOTP/DHCP tool.
3.
Using the MAC address to identify the NET-BOX, select the NET-BOX
in the ‘Discovery History’ window
and click ‘Add Relation’.
4.
Configure the required IP address setting in the pop-up window and click OK.
5.
Open an internet browser and type in the IP address of the NET-BOX.
6.
Navigate to ‘Configuration’ under the ‘NETWORK’ menu.
7.
Set DHCP to ‘Disabled’ and click ‘Save settings’
8.
Cycle power to the NET-BOX or press and hold the reset button until the LEDs turn red then release to
reset the device. The NET-BOX will restart with the configured IP address and with DHCP disabled.