IDEC WB1F Series, Руководство пользователя

Страница: 50 / 116

2. Installation & wiring Function 4. Support tool 5. Appendix 1. Overview
3-27
Slave mode
z
Control commands
The WB1F can be controlled by inputting control commands from the host device to the WB1F.
An example of the control command output format is as follows.
Example: To send the "indicator LED (red) on" control command
z
Request (host device → WB1F)
Prefix Mnemonic Suffix
^ leda1 CR LF
z
Response (WB1F → host device)
Normal response
Prefix Judgment Suffix
^ OK-00 CR LF
Error response
Prefix Judgment Suffix
^ NG-ff CR LF
z
The error response is when a fault occurs such as a mistake in command input.
z
For the other communication commands, refer to
F
P. 5-6 "5. 5 Control commands list" .
z
The check digit can be added to the control command response.
z
The response time for control commands (excluding save, initial) is within 10 ms. The save command is with-
in 2 s, the initial command is within 10 s.