IDEC WB1F Series, Руководство пользователя

Страница: 26 / 116

2. Installation & wiring Function 4. Support tool 5. Appendix 1. Overview
3-3
Slave mode
3. 2 Slave mode
RS-232 Type USB Type
This operation mode is used during normal operation. Use the unit in this mode after installation.
Slave mode has the following functions.
z
Barcode reading ......................................................
F
P. 3-4
z
Output data additional information ................
F
P. 3-11
z
Output data editing ...............................................
F
P. 3-16
z
Matching method ...................................................
F
P. 3-18
z
Analysis .......................................................................
F
P. 3-23
z
Command alias ........................................................
F
P. 3-24
z
Communication command .................................
F
P. 3-26
3. 2. 1 Switching operation to slave mode
There are two methods to switch to slave mode.
Use the methods according to the situation.
The indicator LEDs (red/orange/green) will turn off when switching to slave mode.
Method 1 Turn on the power to the unit. (Do not push the Operation button)
Turn on power supply
Indicator LED
Off
(G)
(O)
(R)
Method 2 Input the "switch to slave mode" control command.
Control command
Indicator LED
Off
(G)
(O)
(R)
Host device
Switch to slave mode