IDEC MICROSmart FC6A Series, Руководство пользователя

Страница: 214 / 578

3: I
NSTALLATION AND
W
IRING
3-32 FC6A S
ERIES
MICROS
MART
U
SER
’
S
M
ANUAL
FC9Y-B1722
Replacing the Backup Battery
This section explains how to replace the backup battery.
Replace the backup battery within 1 minute.
(The position of the battery holder is located on the right side of the top of the All-in-One CPU module and CAN J1939 All-in-One
CPU module, and it is located on the left side of the top of the Plus CPU module.)
1.
Grip both ends of the battery holder, and then pull it out.
The battery holder pulls out to a length of 36 mm.
2.
Remove the dead backup battery from the battery holder.
Orient the battery holder with the
side facing up. While pulling on the outside hook (1), press the backup battery from
below (2).
3.
Insert a new backup battery into the battery holder.
Orient the battery holder with the
side facing up. Orient the new backup battery with the side facing up. Press the
backup battery into the inside hook of the battery holder (1), and then press down on the battery until you hear a click from
the outside hook (2).
Note: Exercise caution regarding the orientation of the backup battery when you insert it.
All-in-One CPU Module
CAN J1939 All-in-One CPU Module
Plus CPU Module
Battery Holder
Backup Battery
Side of the Battery Holder
Outside Hook
(2)
(2)
(1)
(1)
Backup Battery
Side of the Battery Holder
Inside Hook
Outside Hook
(2)
(2)
(1)
(1)