IdAutomation SC7USB 2D, Руководство по программированию

Страница: 23 / 137

Scan
Manual Trigger, Low Power ( For RS-232 only)
The scanner powers down until the trigger is pulled. When the
trigger is pulled, the scanner powers up and operates until there is
no triggering for the time set with the
Low Power Time-Out
barcode below. There is a delay of up to one second in operation
when the scanner is first triggered, but there is no delay when
operating in low power time-out mode.
Low Power Time-Out Timer
Scan the Low Power Time-Out barcode to change the time-out
duration (in seconds). Then scan the time-out duration (from 0-300
seconds) from the inside back cover, and
Save . Default = 120
seconds.
If the unit remains idle during the low power time-out interval, the
unit goes into low power mode. Whenever the trigger is enabled,
the low power time-out timer is reset.
Auto-Sense Mode
This programs the scanner to work in Auto-sense mode. The LEDs
are either off or at the lowest power for ambient conditions until a
barcode is presented to the scanner. Then the LEDs turn on
automatically to read the code. Auto-sense Mode uses ambient light
to detect the barcodes. If the light level in the room is not high
enough, Auto-sense Mode may not work properly.
19