ID Technology 252, Инструкция оператора / Техническое руководство

Страница: 72 / 164

Model 252
Label Printer/Applicator
Operators/Technical Manual
47
5.5 Setting Online/Offline
When taking the applicator offline, the optional three stage beacon will change to red.
While the printer/applicator is offline, the operator may make changes to the setup,
change speeds and/or delays, jog the printer/applicator and simulate label application.
The printer/applicator will remain offline and not respond to any photocell inputs until
the Online/Offline button is pressed again and indicates and “Online” condition.
5.6 Setting the Label Sensor (Apply Only Module)
If the printer/applicator is to be used with a Model 250A Label Feed Module, refer to the
Model 250A Operator/User Manual for set up procedures.
5.7 Air Assist Delay
Open the Dwells and Delays Menu to locate the Assist Delay icon . Pressing the
Assist icon opens the adjustment screen. Air Assist Delay is used to allow the label to
partially feed out before the air assist is turned on. Adjust the delay time with the up or
down arrows and press the Enter icon to save the value. Press the Back icon to discard
the changes.
Use the multiplier icon to make changes in the “times” factor when
adjusting the dwells and delays timing - x1, x10, x100, or x1000ms. Refer to
the Multiplier section for further assistance.