Titan Elite Installation
DANGER!
1) Do not attempt to adjust your Elite arm un-
til everything you intend to mount to the arm is
mounted.
2) Arm must be completely horizontal (extended)
before adjusting the arm’s tension. Failure to do
so will damage the arm and void the warranty.
3)
Never loosen or remove any
of the shoulder bolts. Doing so
will cause the arm to immedi-
ately come apart with tremen-
dous force, and could cause
serious injury.
4) If equipment requiring AC power is mounted
to this unit, have a certified electrician inspect the
installation.
5) Failure to install this unit according to these
instructions will void all ICW warranties. If in-
stalled incorrectly, ICW is not liable for any dam-
age or injury caused by the unit.
The Elite arm contains high
pressure gas springs. The fol-
lowing cautions MUST be ob-
served to avoid serious injury.
Shoulder bolt
1
Remove the ceiling mount from the box, and find
the 4 #14 wood screws in the hardware bag. Firmly
secure the ceiling mount to a solid stud in the ceiling using
the 4 provided screws and being sure the mount is level.
Loosen the set screw in the ceiling mount and thread the
extension pipe fully into the ceiling mount and retighten
the set screw.
2
Remove the long arm cover by unscrewing the
(2) 6-32 flathead screws using a Phillips head
screw driver.
3
Remove the end covers by unscrewing the
(2) 10-24 flathead screws using the 1/8” hex key.
4
Disassemble the upper arm using the provided
socket wrench and 5mm hex key. Keep track of
all parts.
Slip the end
caps out of
the arm.
Do not disassemble these bearing packs.
3/8” Nylock,
split washer
and race
Ceiling mount
Extension pipe
