ICU Medical LifeCare PCA, Техническое и сервисное руководство, Страница: 103 / 148

7.3 REPLACEMENT PROCEDURES
Technical Service Manual 7 - 11 LifeCare PCA
7.3.7
PATIENT PENDANT ASSEMBLY REPLACEMENT
No tools are required for this procedure.
The replacement part for this procedure is:
Assembly, Patient Pendant
To replace the patient pendant assembly, see
Figure 7-4
, and proceed as follows:
1. Disconnect the infuser from AC power.
2. Disconnect the patient pendant assembly from the patient pendant jack on the rear
of the infuser.
3. Connect the replacement patient pendant assembly to the patient pendant jack.
Note: Verify the LifeCare PCA replacement patient pendant cord is color-coded
blue and the switch button is black.
Replacement of the patient pendant assembly is routine maintenance and no verification
procedure is normally required. However, if the infuser may have been damaged during
this procedure, perform the PVT in
Section 5.6
.
7.3.8
FRONT ENCLOSURE ASSEMBLY COMPONENT
REPLACEMENT
Front enclosure assembly component replacement includes removal or replacement
of the following:
To replace the front enclosure assembly components, see
Figure 7-5
and
Figure 7-6
,
and proceed as detailed in the following sections.
CAUTION: Do not bend the patient pendant cord near the patient pendant
or connector jack at an angle of 90
o
or greater.
- Security door
- Door hinge
- Keypad
- Door latch hook
- Cradle assembly
- Mechanism lever arm
- Door latch assembly
- Door lock assembly
- Handle gasket
- Enclosure gasket
- Electronics assembly and components
- Antenna PWA
- CE PWA
- LCD window
- Mechanism assembly
- Barcode reader, gasket, and window
- Splash shield