Hybrid Ultra
855-350-050_Rev2.0_Instruction Manual
Page
62
of 84
Alarm Input #
Alarm Name:
Set a meaningful name to suit the installation (these will
be used for e-mailed alarm messages).
Contact Type:
Set the form-C behavior for each device to be monitored.
(Not Used, Normally Open, Normally Closed) Select Not Used for all
unused alarm input channels. The default setting is Not Used.
Activate Alarm Form C Contact:
Set the check box to have the unit
send a form-C alarm for an alarm condition. The default setting is
Enabled.
Send E-mail:
Select the check box to have an e-mail sent to the e-mail
addresses set up on the communications page for an alarm condition
(see Section 4.8.3).
NOTE: Save Settings before selecting a different tab.
4.8
Communications
Use this tab to configure the basic system parameters, network settings, e-
mail settings, user setup, and maintenance functions.
4.8.1
BASIC SETUP
Use this tab to configure the unit’s name, set the date and time and enable
the watchdog timer and data logging features.
Power System Device Info
Device Name:
Enter a descriptive name for the system. This name will
be used in all e-mail messages.
Model:
Shows
the model number, series name, and voltage
configuration.
Hardware:
Shows the hardware version.