Installation 2-1
Chapter 2
Installation
Card Setup
The PCI-16REL board is a fully compliant PCI “Plug-n-Play” adapter.
I/O address is auto assigned by either your system BIOS or your “Plug-n-Play”
operating system.
Software Installation
For Windows Users
Run setup from floppy disk 1. Then, install
SeaI/O
and select the
Digital I/O
software drivers. For users of DOS, Windows 3.1, etc., run disk 3 and the Read
Me file.
System Installation
The PCI-16REL can be installed in any PCI expansion slot as follows:
1) Turn off system power. Disconnect the power cord from the electrical
outlet.
2) Remove the chassis cover.
3) Locate an available PCI slot and remove the associated slot filler
bracket from the rear panel of the chassis.
4) Gently insert the PCI-16REL board into the slot. Make sure that it is
seated properly.
5) Secure the board’s slot bracket to the rear panel with a screw.
6) Replace the chassis cover.
7) Plug the power cord into an electrical outlet.
Содержание PCI-16REL
