ICS Schneider Messtechnik HYDROTECHNIK MultiHandy 2025, Руководство по эксплуатации

Страница: 15 / 24

EN
7 Channels
13
7 CHANNELS
The measuring instrument has three channels:
•
C1
and
C2
for sensors at connections CH1 and
CH2.
•
C3
as a special channel for calculations from
measurement values
C1
and
C2
.
7.1 Displaying/hiding channels
You can switch the display for every channel on or off.
How to switch the display for a channel on or off
1 Press
[MENU]
to open the
MAIN MENU
.
2 Use the
[MENU]
to open the
CHANNELS
menu.
3 Use
[F1]
to select the desired channel.
4 Press
[F3]
to switch the display on or off.
The eye icon is shown when the display is
switched on for a channel.
5 Press
[F4]
until the display shows the measure-
ment values again.
7.2 Configuring channel
If you are using a sensor without ISDS, you have to
configure a channel. You need a corresponding pa-
rameter for the sensor. They are on the sensor or in
the sensor data sheet.
The measuring instrument only detects ISDS sensors
when the measuring instrument is being switched on.
You can configure an ISDS sensor manually if you do
not connect it until the measuring instrument is
switched on.
You must define the following parameters during the
configuration:
•
C1/2
: Measurement variables and unit of meas-
urement
•
Signal
: Signal type and range, if applicable
•
Range
: Measurement range or calibration value
A Channel
B Measurement varia-
bles and unit of
measurement
C Icon for display
A B C