16
Option 2: USB Extender Direct Surface Mounting
The bottom of the Raven enclosure features four pre-drilled holes for optional surface mounting.
Distance between the enclosure mounting holes:
On the LEX unit: 42.0mm x 130.5mm
On the REX unit: 42.0mm x 163.0mm
1. Mark the center point of each of the four holes on your mounting surface either by directly measuring or
printing the templates:
|
.
2. Hardware recommendation: M3 locking washers and M3 screws (4 of each per extender) noting screw length
will depend upon thickness of mounting surface.
3. Drill through each of the four hole markings on the mounting surface using a 3.97mm (5/32”) drill bit.
4. Align the bottom enclosure holes to the newly drilled out holes on the mounting surface.
5. Place a locking washer on each of the four screws and using a screwdriver, fasten the extender into place.
NOTE:
Do not exceed a screw depth of 10mm (0.4”) into the unit or damage may occur.
Direct Surface Mounting Measurement Stencils
The stencil illustrations pictured below are only 50% of the original size. Access each stencil file (to scale) by
clicking the illustration or link.
https://www.icron.com/pdf/3204c-series-lex-stencil.pdf
https://www.icron.com/pdf/3204c-series-rex-stencil.pdf
mounting hole
