C-6
ICP Flash Utility (IFU)
SAVE
The
SAVE
command saves the contents of a controller’s flash in a
UFI file. The name of the UFI file is based on the controller type
and cannot be changed.
You must restart the computer following a
SAVE
command.
Command Syntax
The command syntax for the
SAVE
command is as follows:
IFU SAVE [/C<Controller ID>] [/D <UFI File Path>]
Command Switches
The following switches are available:
■
/C
<Controller ID>
is one or more controller IDs representing
the set of controllers on which to perform the specified
command. The default is 0, which means that if the computer
has multiple controllers, the IFU defaults to controller 0 unless you
specify otherwise.
You can specify a single controller ID, for example:
/C 0
multiple IDs separated by commas, for example:
/C 0,2
or
ALL
to indicate all controllers.
Note:
If you are using multiple controllers, you must specify
the controller you want by using the
/C
switch; otherwise, the
IFU displays an error message and exits.
■
/D <UFI File Path>
specifies the path (drive and directory)
where the UFI files are located. If you do not specify the
/D
switch, the IFU looks for, or creates, its UFI files in the default
location.
Note:
You cannot specify the name of a UFI file, only its path.
UFI filenames are predefined, based on controller type.
