ICP DAS USA PMC series, Руководство пользователя, Страница: 111 / 340

ICP DAS PMC/PMD Series User Manual
98
7.3.1 Scan to Add ICP DAS M-7000/DL Modules
The user could use Scan function to add ICP DAS M-7000/DL
Modules to the PMC/PMD, the steps are as below:
i Click on button to scan the M-7000/DL modules that are
connected to the PMC/PMD.
Figure7-27 :
The “Scan” button to search M-7000/DL module
ii When the Scan page appears (Figure 7-28), input the starting
address and the ending address of the Modbus address that are going
to perform scan. Click on “Scan”, the system will start to scan the
M-7000/DL modules that match the settings previously set, to
cancel the scan, click on “Cancel”.
Figure7-28 : Set up the Scanning Range for the M-7000/DL module
iii When the system is performing the scan (Figure 7-29), the address
that are performing scan will be dynamically shown on the upper
left side, please wait till the scan operation is completed. To stop the
scan operation, click on “Cancel” to terminal the scan and leave the
page.