ICP DAS USA PMC-523 Series, Руководство пользователя

Страница: 117 / 347

ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
102
Please Note:
1. For M-7000 modules, the counting mode of the DI channel
counter is Falling.
2. To set up the default value of the DI channels on M-7000
modules, please use DCON Utility to set the value.

The DO channel setting for M-7000/DL module
The M-7000/DL module DO channel setting interface is shown as
below (using M-7060 as an example)
Figure7-39 : M-7000/DL DO Channel Setting Page
The settings are as below:

Nickname
：
For user to define nickname for each I/O channel,
this nickname will be displayed on the “I/O Information” and
“Rule Setting” pages.

For M-7000/DL DO channels, PMC/PMD provides the
following options for advanced function:

Disable: Disable the advanced function
 Auto OFF: When “Auto OFF” is selected, it allows this
DO channel to enable Auto OFF function. It is required to set
up a time interval, when this DO channel is set to be “ON”
and the duration of the ON status reaches the pre-set time
interval , the DO will automatically be set to OFF. The unit is
second.
 DI Status Mapping: When “DI Status Mapping” is selected,