PISO-CANFD series CAN FD card User Manual (version 1.0.0)
Page: 11
Copyright © 2021 ICP DAS Co., Ltd. All Rights Reserved.
E-mail: [email protected]
1.3.3. Board Number Switch Settings
The following provides a description of the SW1 DIP switch, which can use to
configure board number of the PISO-CANFD series board.
Switch
Description
Status
SW1
SW1 is a DIP switch that is used to configure the
board number for the PISO-CANFD series card.
For example, if the switch on the left-hand side,
(ex., DIP switch 1, is set to ON, as indicated in the
figure, the board number will be set to 1. The
board number can range from 0 to 15.
Note that
the board number for each PISO-CANFD
series card installed in the Host PC must be
unique.