1.5 Hardware
Configuration
This chapter describes how to unpack this I/O card and how to install it to your
system. Both the unpacking information and the jumper settings are described
in the following text. This manual should be carefully read before installation.
1.5.1 Unpacking
This I/O card was well-tested and inspected both mechanically and electrically
before shipping. It was free of marks and scratches our quality delivery policy
requires that all equipment be in perfect order before delivery. However, some
unconditional damages may occur while unpacking!! Please read this section
before unpacking the card. Feel free to contact your carrier and retain your
carton in case there is error.
1. This card should be packed with an anti-static mat.
2. The user should wear an anti-static wristband, grounded at the same point to
the anti-static mat.
3. Inspect the carton for obvious damage. Either shipping or handing may
cause damages!! Be sure there are no shipping and handing damages on
the card before using.
4. After opening the carton, place the system board handle on a grounded anti-
static surface and let the component side up.
This card contains sensitive electronic components that can be easily
damaged by static electricity.
CAUTION: Do not apply power to the board if it has been damaged!
CAUTION:
5. You are now ready to install your card.
PCI-P16R16 Series User Manual (Ver.2.8, Apr. 2011, PMH-013-28)
9