ICP DAS USA ISaGRAF I-8437-80, Начало работы

Страница: 56 / 78

Getting Started: I-8437-80/8837-80/8417/8817, Jul 2020 V2.0 56
3.9 Setting I-8437-80/8837-80’s IP & MASK & Gateway
Download ISaGRAF driver for the PAC on the website and then extract the zip file:
https://www.icpdas.com/en/download/show.php?num=368
1.
Create a folder named
“
8000” in the hard drive (e.g., “c:\8000”).
2. Copy "7188xw.exe", "7188xw.ini", "7188xw.f4", "isa.exe", "autoexec.bat", and
"8k050408.img" from the driver folder to the “8000” folder.
3. To check that the serial connection (e.g., ‘COM1’) between a PC and a PAC is functional
through a RS-232 cable. Refer
Section 3. 11 step4 to modify the “7188xw.ini” file if using
other COM port (e.g., ‘COM5’).
4. Launch the Command Prompt window and type “ipconfig” to display the network
configuration of the PC.
5. Power off the PAC, connect pin
“
INIT
”
to
“
INIT COM
”
, and restart the PAC.
6. Run
“
7188xw. exe
”
on PC and a
“
7188xw
”
screen will be displayed. If the connection is Ok,
“i-8000>” will be shown on the screen. (Also, press Enter to check the connection.)
Note that configure the following settings (IP/Mask/Gateway) according to the network
configuration of the PC.
7.
Type
“
ip
”
to see the current IP address of the PAC.
Type
“
ip 10. 0. 0. xxx
”
to setup a new IP address.