ICON ProAudio HyperDrive HD1, Быстрый старт

Страница: 7 / 11

7
Set Up
Gain
：
1X 23dB
2X 46dB
(1K Ohms)
Gain
：
1X 23dB
2X 46dB
(1K Ohms)
The Hyperdrive HD1 is an active microphone amplifier intended to be inserted
between a passive ribbon or dynamic microphone and a microphone preamplifier.
There are two ways to connect as depicted in the diagram above.
The first (Fig. 1) – Connect the Hyperdrive HD1 directly into your pre-amp interface,
then connect your dynamic or ribbon mic to an XLR lead as normal.
On your sound
device: ensure power is off and volume is zero. Then switch on and gradually
increase volume to taste.
The second (Fig. 2) - connect your Hyperdrive HD1 unit to your microphone. Then,
plug your 3 pin XLR cable into the end of the Hyperdrive HD1, connecting the
cable to your pre-amp interface. On your sound device: ensure power is off and
volume is zero. Then switch on and gradually increase volume to taste.
As a precaution, please turn the volume relatively low (preferably zero) when
switching between 1x 23dB and 2x 46dB in order to prevent pops or immediate
increases in volume, especially in a live setting.
Fig. 1
Fig. 2