11
11 RADAR SETTINGS
11.1
C
OMMUNICATION
•
The TMA-3B3 can be configured by serial communication (115200 bauds 8N1).
•
It needs to be disconnected from the modem and connected to a PC equipped with a serial port (or via an USB-Serial (RS-232)
adapter).
•
Please note that the modem should be reconnected to the TMA-3B3 after its configuration.
11.2
C
ONFIGURATION OF THE RADAR USING THE
I
COM
S
OFT
TMA-3B3
Firstly, power on the radar.
Secondly, launch the software by executing the tma3b3config_Vx.y.z.exe program (x, y and z refer to the version numbers). It will
open a DOS window and will take some time to launch the Graphical User Interface (GUI), please be patient while the software starts
up.
Figure 14: IcomSoft TMA-3B3 GUI when first opened
11.2.1
Tabs
There are two tabs:
•
The
“Background
config” tab, used to configure the background of the lidar.
This tab shows
the “raw” range (the true range measured by the lidar)
. The limit must be fixed to reject objects that are farther
away than this limit.
•
The
“Hybrid
config” tab, used to configure the limits of the bike lane (in speed and range).
This tab shows the range (top) and the speed (bottom) of the detected objects. The range here is taken perpendicularly to the
bike lane (that is, taking into account the horizontal installation angle of 45 °).
