INSTRUCTIONS
SEPARATION KIT
RMK-2
Thank you for purchasing the
RMK-2
SEPARATION KIT
.
The RMK-2 allows you to install the IC-F1700 series
transceiver front panel separately from the main unit
for added installation convenience and operation.
Use either the optional OPC-607, OPC-608 or OPC-
609
SEPARATION CABLE
with the RMK-2.
■
Separation
The optional OPC-607
(3 m; 9.84 ft)
, OPC-608
(8 m; 26.3 ft)
or
OPC-609*
(1.9 m; 6.3 ft)
SEPARATION CABLE
is required for in-
stalling the transceiver front panel and main unit separately.
*For Europe version, only the OPC-609 is available.
q
Turn the transceiver’s power OFF, then disconnect the DC
power cable.
w
Unscrew the 4 bottom screws, then remove the bottom
cover from the transceiver in the direction of the arrow.
e
Disconnect the flat cable and speaker cable* from the
main unit.
r
Unscrew the 2 side screws, then remove the front panel
from the transceiver main unit in the direction of the arrow.
t
Unscrew the 4 screws, then remove the rear plates from
both the front panel and main unit attachments.
☞
Continue to the back page.
Rear plate
*This illustration shows
the description for the
front panel attachment.
Unscrew the cir-
cuit board screw.
Main unit
Front panel
Flat cable
Speaker cable*
*Depending on version
Bottom cover
CAUTION!
To avoid damage to the transceiver, turn the
power OFF before separating from the main unit.
■
Supplied accessories
Main unit attachment
Front panel attachment and bolts (M3
×
15)
Flat cable
Mounting bracket
Flat washers
(M5)
Spring washers
(M5)
Mounting screws
(M5
×
12)
Self-tapping screws
(M5
×
16)
Bracket screws
Nuts (M5)
Icom, Icom Inc. and the
logo are registered trademarks of Icom Incor-
porated (Japan) in the United States, the United Kingdom, Germany, France,
Spain, Russia and/or other countries.
RMK-2_2.qxd 05.11.9 18:30 Page 1