Icom M-330GE, Инструкция по эксплуатации

Страница: 72 / 80

60
11
TROUBLESHOOTING
60
PROBLEM POSSIBLE CAUSE SOLUTION REFERENCE
The transceiver does
not turn ON.
• Bad connection to the power supply.
• The fuse is blown.
• Check the connection to the transceiver
and power supply.
• Repair the problem, and then replace
the fuse.
p. 53
p. 54
Little or no sound
comes from the
speaker.
• Squelch level is set too high.
• Volume level is set too low.
• Set the squelch to the threshold point.
• Set the volume to a suitable level.
p. 11
p. 11
You cannot transmit
with high power.
• Some channels are set for low power or
receive only by regulations.
• The output power is set to low.
• Change channels.
• Push [HI/LO] to select high power.
pp. 9,10
p. 6
Scan does not start. • More than 2 favorite channels are not set. • Set the Favorite channels. p. 16
No beep sounds. • The Key Beep function is OFF. • Turn ON the Key Beep function. p. 47
Individual or Group ID
cannot be set.
• The entered ID code is incorrect.
First digit must be set to between ʻ1ʼ and
ʻ9ʼ for an Individual ID.
First digit must be set to ʻ0ʼ for a Group ID.
• Enter a correct ID code. pp. 18, 19
“??” blinks instead of
the position and time.
• 23.5 hours have passed since you
manually entered the position.
• The GPS position is invalid.
• Enter the position and time. p. 20
“NO POSITION”
and “NO TIME” are
displayed instead of
the position and time.
• The GPS signal is not correctly received.
• The position and time have not been
manually entered.
• Check the GPS antenna connection
and position.
• Check the NMEA input connection.
• Enter the position and time.
p. 54
p. 53
p. 20