5
OPTIONAL PRODUCTS
5-11
Function
Operation
Comfirmation beep
Bluetooth indicator
Turning ON the Bluetooth
function
Hold down the [Bluetooth] button for 3 seconds.
Melody sounds (Scale goes up)
Blinks blue
Turning OFF the Bluetooth
function
Hold down the [Bluetooth] button for 3 seconds.
Melody sounds (Scale goes down.) OFF
Pairing
When the Bluetooth functon is OFF, hold down the
[Bluetooth] button for 6 seconds
Ready to connect: "PiPa-"
Alternatively Blinks red and blue
while waiting for a connection.
Connected:
"
PiRo"
Blinks blue twice every
3 seconds when connected.
Making a call*
1
Push [PTT].
"Pi"*
2
(Default)
Blinks red once then Blinks blue
twice every 3 seconds.
Setting the volume up*
1
Push [+]
"Pi"
( High tone sounds when the volume
is set to the maximum level.)
―
Setting the volume down*
1
Push [-]
"Boo"
( Low tone sounds when the volume
is set to the mimimum level.)
―
L
If the Bluetooth function is ON and the pairing list is blank, the VS-3 starts up in the Pairing mode.
*
1
Functional only when a Bluetooth device is connected.
*
2
The melody differs, depending on the “Calling Notice Tone” item (p. 4-4) or “Bluetooth PTT Beep” item (p. 4-7) in the Set
mode.
■
Charging VS-3
Fully charge the VS-3 before using. Charging is also
necessary when the LED blinks red every 3 seconds.
1. Make sure the headset power is OFF.
•
If it’s ON, hold down [PWR] for 3 seconds.
2. Open the USB port cover, and then connect the
VS-3 to a USB power adapter, or a PC, with the
supplied USB cable.
•
While charging, the LED lights red.
•
When the charge is completed, the LED turns OFF.
R
DANGER!
The charging time is approximately 3 hours.
If the LED does not turn OFF after 3 hours of charging,
disconnect the USB cable to stop charging.
Overcharge may degrade the battery performance or
shorten battery life. Also, it may cause a fire or explo
-
sion.
While charging, you cannot use the headset.
PC
USB power adapter
(user supplied)
VS-3
To a USB port
NOTE:
•
If the headset does not operate normally,
try the following to perform a force power OFF.
•
When the volume is set to too low in level,
the audio may not be loud enough to hear.
Setting the volume level to “28” or higher is recommended.
Earphone jack (3.5 (d) mm)
Charging port
Microphone
[PTT]
[VOL] (+)
[VOL] (–)
LED
[PWR]
Clip
[FWD]*
[PLAY]*
[RWD]*
[RESET]
* [FWD], [RWD] and [PLAY] keys on the VS-3 are not functional.
