Icom IP100H, Инструкция по эксплуатации, Страница: 31 / 33

7
FOR YOUR REFERENCE
7-2
Troubleshooting
The following chart is designed to help you correct
problems which are not equipment malfunctions. If you are unable to locate the cause of a problem, or
solve it through the use of this chart, contact your near-
est Icom Dealer or Service Center.
PROBLEM POSSIBLE CAUSE SOLUTION REF.
No power comes ON. The battery charge is exhausted. •
Loose connection of the battery pack •
(case).
Charge the battery pack, or replace the •
batteries.
Clean battery pack (case) terminals.
•
pp. 2-4
2-6
–
No sound comes from the
speaker. Volume level is too low. • Rotate [PWR/VOL] to adjust to a desired •
level.
p. 3-2
No reply is received Too far from an access point. •
The “ • ” icon blinks.
The operator is away from the terminal, or •
the terminal is turned OFF.
Move your location, then try again. •
Wait until the operator is back, or ask sys- •
tem manager about the status.
–
–
“Key lock” is displayed
when a key is pushed The Key Lock function is turned ON. •
Hold down [CLR• • ] for 1 second to
turn the Key Lock function OFF.
p. 3-3
Cannot charge the battery
pack completely The communication terminal power is •
ON.
Turn OFF the power. • p. 2-4
The charging indicator
blinks orange, or alternately
blinks orange and green The battery pack is not properly inserted. •
Charging the battery pack outside of the •
chargeable temperature range.
Loose connection of charging terminals. •
The communication terminal power is •
ON.
Insert the battery pack properly. •
Charge the battery pack in the charge- •
able temperature range:
BC-202: 0°C to 40°C (+32°F to +104°F)
BC-211: 10°C to 40°C (+50°F to +104°F)
Clean the charging terminals. •
Turn OFF the power. •
p. 2-4
p. 2-3
–
p. 2-4
The “ ” icon blinks, or
“Connecting…” is displayed
( standby screen won't be
displayed)
SSID Broadcast function is OFF in an ac- •
cess point (when 5 GHz band is used).
Too far from an access point.
•
Access point power is OFF. •
Ask your system manager about the ac- •
cess point settings.
Move your location, then try again.
•
Turn ON the access point power. •
–
–
–