7
NXDN™ OPERATION
7-8
Transmitting a call (Continued)
D
Transmitting a Status message
You can transmit a preset simple message.
You cannot transmit a voice signal at the same time.
<Menu operation>
TIP:
The Portable type transceiver’s operations are
described in
red
. And the Mobile type transceiver’s
operations are described in
blue
.
L
The common operations are in black.
Using the Contact menu:
(MENU > CONTACT >
STATUS
)
1. Push [Menu] to display the Menu screen.
•“CONTACT” is selected.
Portable
ENT
BACK
CONTACT
Mobile
M E N U
C O N T A C T
2. Push
[P1](ENT)
or
[P2]
.
•
The current call type is briefly displayed, then the
Contact menu screen is displayed.
L
To change the call type, see page 7-3.
3. Push
[P2](
Ω
) or [P3](
≈
)
or
[
Ω
P3] or [P4
≈
]
to
select the destination ID, then push
[P1](ENT)
or
[P2]
.
Portable
CONTACT 1
TG1
ENT
BACK
Mobile
C O N T A C T
1
T G 1
TIP:
If “DIRECT DIAL” is selected, you can
manually enter a target ID. See page 7-32 for
details.
4. Push
[P2](
Ω
) or [P3](
≈
)
or
[
Ω
P3] or [P4
≈
]
to
select “STATUS,” then push
[P1](ENT)
or
[P2]
.
•Enters the Status Message Selection mode.
Portable
TG1
STATUS
ENT
BACK
Mobile
T G 1
S T A T U S
5. Push
[P2](
Ω
) or [P3](
≈
)
or
[
Ω
P3] or [P4
≈
]
to
select a status message.
Portable
STATUS 1
TX Status 01
TX
BACK
Mobile
S T A T U S
1
T X
S t a t u s
0 1
6. Hold down
[P1](TX)
or
[P2]
to transmit the status
message to the selected station or Talkgroup.
• “STAT OK” is displayed after receiving an
acknowledgement from the target station.
• “STA FAIL” is displayed if the target station does not
send back an acknowledgement.
Previous view
