5
D-STAR OPERATION (ADVANCED)
5-33
Entering new information into the repeater list
Step 7. Changing the repeater group
L
The repeater group that is selected in
Step 1.
Selecting the repeater group
is displayed� You can
skip this setting and go to the next item� To change
the group, follow the steps described below�
1� Select “GROUP�”
2� Select the repeater group� (01 ~ 50)
Step 8. Setting “USE(FROM)” to be used as an
access repeater
L
You can use the entered repeater as an access
repeater when using the DR function� When not
using as an access repeater, select “NO,” and go
to
Step 15. Selecting the position data accuracy
level
� In that case, the entered repeater is not
displayed in “FROM” on the DR screen�
1� Select “USE(FROM)�”
2� Select “YES” to use the repeater as an access
repeater�
Step 9. Entering the access repeater frequency
1� Select “FREQUENCY�”
2� Rotate [DIAL] to enter the repeater frequency�
L
Push D-pad(
) to move the cursor�
3� After entering, push [ENT]�
D
Entering new information into the repeater list
Step 10. Selecting the Duplex direction
L
When
Step 2. Selecting the communication type
is set to “DV Simplex” or “FM Simplex,” this item is
not displayed�
L
“DUP–” is automatically set when the access
repeater frequency is entered in
Step 9. Entering
the access repeater frequency
� If necessary, you
can change the Duplex direction�
1� Select “DUP�”
2� Select a Duplex direction�
•
OFF:
Turn the duplex function OFF�
•
DUP–:
The transmit frequency shifts down from the
receive frequency by the offset amount�
•
DUP+:
The transmit frequency shifts up from the
receive frequency by the offset amount�
Step 11. Entering the frequency offset
L
When
Step 2. Selecting the communication type
is set to “DV Simplex” or “FM Simplex,” this item is
not displayed�
L
The offset value* is automatically set when the
access repeater frequency is entered in
Step
9. Entering the access repeater frequency
� If
necessary, you can change the frequency offset�
* The default value differs, depending on the transceiver
version�
1� Select “OFFSET FREQ�”
2� Rotate [DIAL] to enter the frequency offset
(0�000�00 ~ 59�995�00 MHz)�
L
Push D-pad(
) to move the cursor�
3� After entering, push [ENT]�
