12
MEMORY OPERATION
12-4
■
Entering a Memory channel
q
Push [V/MHz]
to select the VFO mode.
w
Set a desired frequency and operating mode:
➥
Rotate [DIAL] to set a desired frequency.
(Example: 146.030)
➥
Push [MODE]
one or more times to select a
desired operating mode. (Example: FM mode)
➥
Set the duplex direction, frequency offset, tone
squelch, and so on, if needed.
e
Hold down [S.MW]
for 1 second to enter the Se-
lect Memory write mode.
• 1 short and 1 long beep sound.
• The memory channel number blinks, and memory con-
tents are displayed.
r
Rotate [DIAL] to select a desired channel to be pro-
grammed.
(Example: Channel 11)
t
Hold down [S.MW]
for 1 second to program, and
then return to the VFO mode.
• 3 beeps sound.
• Before returning to the VFO mode, the programmed
memory contents are briefly displayed.
• The Memory channel number automatically increases
when continuing to hold down [S.MW]
for 1 second
after programming.
[DIAL]
Set 146.030MHz in
the VFO mode.
Hold down [S.MW]
for 1 second to enter
the Select Memory write
mode.
Rotate [DIAL] to select a
channel 11.
Hold down [S.MW]
for 1 second to program.
Returns to the VFO mode.
Example: Programming 146.030 MHz/FM mode into
memory channel 11 (a blank channel).
NOTE:
Push [CLR]
to cancel the program and
exit the Select Memory write mode before memory
programming.
Previous view
