10
GPS OPERATION
10-38
D
Using <<GPS Logger Only>> mode
The transceiver has an exclusive GPS logger mode
where only the logger is functioning.
This mode is useful when you are traveling and don’t
want to use the transceiver for communication, but you
do want to use just a GPS logger.
NOTE:
In the “GPS Logger Only” mode, the GPS Log-
ger function is ON, but the transceiver function is dis-
abled, until you reboot the transceiver.
<<GPS Logger Only>> outline
1. Insert the microSD card.
( microSD cards are not available from Icom. Pur-
chase a card to meet your needs)
2. Confirm that the GPS receiver is receiving your
position and time.
3. Confirm that the GPS Logger function is ON.
4. Turn ON the <<GPS Logger Only>> mode.
(The <<GPS Logger Only>> mode starts.)
q
Push [QUICK]
.
w
Push D-pad(
) to select “<<GPS Logger Only>>,”
then push D-pad(Ent).
D-pad
(
)
(Ent)
• After the “Only GPS Logger is now functioning”
message appears, then the GPS position is dis-
played to start the GPS Logger Only mode.
Also you can select the <<GPS Logger Only>>
mode in the Menu screen. (p. 16-42)
( MENU > GPS > GPS Logger >
<<GPS Logger Only>>
)
To cancel the <<GPS Logger Only>> mode, re-
boot the transceiver by turning it OFF and then
ON again.
• When the transceiver is tuned ON, the normal GPS
Logger restarts.
If the GPS Logger item in the
Menu screen is set to OFF,
the confirmation screen
“‘GPS Logger’ will be set to
ON. OK?” appears after do-
ing the step
w
.
Push D-pad(
) to select
“YES,” and push D-pad(Ent) to turn the GPS Logger
function ON.
The GPS Information or
Compass Direction settings
can be changed.
In the <<GPS Logger Only>>
mode, push [QUICK]
to open the Sub Menu, as
shown to the right.
Then push D-pad(
) to se-
lect a desired item, and then push D-pad(Ent) to en-
ter.
GPS LOGGER ONLY screen
■
GPS Logger function (Continued)
While a microSD
card is inserted
While GPS indicator
stays ON
Select
Speed
Altitude
Latitude
Longitude
Grid Locator
Your course
heading is
213 degrees
Compass
direction is
Heading Up.
Previous view
