Icom IC-V80, Инструкция по эксплуатации

Страница: 8 / 59

2
Previous view
PANEL DESCRIPTION
2
■
Front, top and side panels
q
PTT SWITCH [PTT]
➥
Hold down to transmit, release to receive. (p. 14)
For IC-V80E only
➥
Quickly push [PTT] once, then immediately hold
down [PTT] again for 1 or 2 seconds, to transmit a
1750 Hz tone burst signal. (p.
19)
w
ANTENNA CONNECTOR
Connect an antenna here. (p. 1)
e
CONTROL DIAL [VOL]
➥
Adjust the audio level. (p. 11)
➥
While in the Set mode, or Initial Set mode, rotate to
select the desired item, option or value.
(pp. 36, 40)
r
EXTERNAL SPEAKER/MICROPHONE JACKS [SP MIC]
Accepts an optional speaker-microphone, plug
adapter cable or cloning cable connector. The inter-
nal microphone and speaker will not function when
an option is connected.
CAUTION: Be sure to turn OFF the transceiver
power, before connecting or disconnecting option-
al equipment to or from the
[SP/MIC] jack.
t
MONITOR KEY [MONI]
➥
Hold down to temporarily open the squelch to
monitor the operating frequency. (p. 11)
➥
While holding down the key, push [
Y
] or [
Z
] to
adjust the squelch level. (p. 11)
➥
Enters or sends the DTMF code ‘A.’
y
POWER KEY [ ]
Hold down for 1 second to turn the power ON or
OFF.
u
UP/DOWN KEYS [
Y
]/[
Z
]
➥
Push to change the operating frequency. (p. 13)
➥
In the memory mode, push to select a memory
channel. (p. 22)
➥
While scanning, push to change the scanning di-
rection. (pp. 26, 32)
➥
While holding down [MONI] , push to adjust the
squelch level. (p. 11)
➥
While in the Set mode, or Initial Set mode, push to
select a setting item. (pp. 36, 40)
➥
[
Y
] enters or sends the DTMF code ‘B.’
➥
[
Z
] enters or sends the DTMF code ‘C.’
i
VFO/MEMORY/CALL KEY [VFO/MR/CALL]
➥
Push to sequentially select the VFO mode, memory
mode, a Call channel or a weather channel*. (p. 12)
*For only USA version of IC-V80.
➥
After pushing [FUNC](
M
) , push to enter the mem-
ory programming mode. (p. 21)
➥
After pushing [FUNC](
M
) , hold down for 1 sec-
ond to transfer a channel’s contents to a memory
channel, or to the VFO mode. (p. 23)
➥
Enters or sends the DTMF code ‘D.’
q
w
e
r
t
y
u
i
Function
display (p. 4)
Keypad (p. 3)
Microphone
Speaker