Icom IC-M94DE, Инструкция по эксплуатации

Страница: 47 / 88

38
9
DSC OPERATION
9
10
15
18
13
11
16
14
12
17
1
7
4
2
8
5
3
6
D
Receiving a Position Request call
NOTE: If the Auto ACK function is set to “Auto,” the Position Reply is automatically sent
to the calling station. (p. 42)
However, even if the Auto ACK function is set to “Manual,” after receiving a Distress
Acknowledgement, or while in the Distress Cancel call procedure, the Position Reply is
automatically sent to the calling station.
When a Position Request call is received:
•An alarm sounds.
•“RCVD POS Request” is displayed.
1. Push to turn OFF the alarm.
2. Push the Software Key below for the intended operation.
:
(Able
Comply)
Sends an Acknowledgement “Able comply”
right away.
•The call is saved in the DSC Log.
:
(Unable
Comply)
Sends an Acknowledgement “Unable Comply.”
•The call is saved in the DSC Log.
• Displays the Acknowledgement information,
and then returns to the operating screen by
pushing .
:
(Accept)
Accepts the call.
•Displays the received call’s information.
•The call is saved in the DSC Log.
•Push , then push to send the
Position Reply call. (p. 34)
:
(Ignore)
Ignores the call and returns to the operating
screen.
•The call is saved in the DSC Log.
•“ ” blinks continuously until you display the
call message.
:
(Hold)
Puts the received call on hold, and returns to
the operating screen.
L
You can check the DSC calls that are on hold
in the Unread List. (p. 41)