12
2001 NEW
5
2001 NEW
5
BASIC OPERATION
1
2
3
4
6
7
8
9
10
11
12
13
14
15
16
17
Quick Refeoence
■
Receiving and toansmitting
D
Receiving
1.
Select a channel by rotating [CH/GRP], or
pushing the keypad keys. (p. 11)
2.
When receiving a call, rotate [VOL] to adjust the
audio output level.
TIP:
When a call is received:
•
The
icon is displayed.
• You can hear receive audio from the speaker.
• The S-meter displays the received signal strength.
D
Toansmitting
1.
Select a channel by rotating [CH/GRP] or pushing
the keypad keys. (p. 11)
2. Push [
Ω
] or [
≈
] to display “TX FREQ Monitor” in
the Software Key area.
3.
Hold down [TX FREQ Monitor]
to temporarily
monitor the transmit frequency of the selected
channel.
• The transmit frequency is displayed and
blinks.
NOTE:
If the channel is busy, wait until it becomes
clear, or change to another channel.
4. Hold down [PTT] on the handset to transmit.
•
is displayed.
NOTE:
If “SWR” is displayed during the transmission,
check your antenna system.
5.
Speak into the microphone at your normal voice
level.
6.
Release [PTT] to receive.
•
is displayed.
NOTE: Foo the Time-out Timeo (TOT) function
The TOT function inhibits continuous transmission
beyond a preset time period after the transmission
starts. 10 seconds before transmission is cut off, a
beep sounds to indicate the transmission will be cut
off. Release [PTT] once to end your transmission
and reset the timer. You cannot transmit for 10
seconds after it is cut off.
IMPORTANT:
To maximize the readability of your
transmitted signal, pause for a second after pushing
[PTT], and then hold the handset 5 to 10 cm from
your mouth and speak at your normal voice level.
[
Ω
]/[
≈
]
[CH/GRP]
Software Keys
KEY PAD
■
DSC scan
To receive a DSC call, such as an Individual call or a
Group call, push [D-SCAN] to enter the DSC watch
mode.
DSC watch mode
NOTE:
The following frequencies are always
automatically monitored with this transceiver.
2187.5, 4207.5, 6312.0, 8414.5, 12577.0, and
16804.5 kHz
[D-SCAN]
[VOL]
